Project Air Cube - Going back to air

Now begins the phase of the project where most of the modification is going to take place, the face plate. Shown below is a fan controller kit. The middle position is off, up is 12 volts, and down is 7 volts. These options should give me the ability to really tune the cooling performance vs. noise levels. The kit includes the electronics, a template made of plexi-glass, and some LED holders. You provide the face plate. Or, you would mount this directly to the case somewhere.

The template has some double sided sticky tape, so you simply line up the template to the face plate and get your drill ready with a 1/4" drill bit.

Shown here with all 12 holes drilled out.

Finished up and ready to mount.

Face Place 2 >>