Project Air Cube - Going back to air

Now it is time to wire up all this crap. There are a ton of wires and many different ways to hide them (as much as possible). I really thought about sleeving everything, but I want to finish this up in the next few days. I might revisit the wiring at a later date and upgrade to a full sleeve job. For now I am going to use some simple plastic wire conduit.

Here I am wiring up the side of the case where the front switch panels are going. There is a lot of wiring here to clean up.

Just a close up of some of the wires.

Getting there...

Here you can see the plastic wire conduit. Not as good looking as sleeving, but I think it looks good enough for now.

Here is the front almost complete. I just need to add some front USB and Firewire to the lower switch panel (not shown here) that sits under the fan controller.

Finishing Up 3 >>