Assembly of the case - Part 2 -

After about 30 minutes the assembly of the case is well under way. It took a few minutes of looking at the instructions to get this going, but once I started it didn't take very long to get it assembled.

Pretty much done here. As you will see later on, the top and sides are all plexi-glass. You can also see here that the motherboard will be laying flat. This is to accommodate the enormous copper heat sink that will be installed later. It weights so much, the manufacture states that you should position the motherboard this way to avoid any damage to your board :)

Here is the front. You can see here that the drives and such will be located at the bottom of the case.

Assembling the case 3 >>